Practical Guide
How to measure your bathroom before buying a sink or commode.
A few measurements taken properly before ordering save a lot of trouble after.
At a glance
1. Overall room size
Measure the full length and width of the bathroom, noting the position of the door and its swing.
2. Fixture positions
Mark where the sink and commode will sit, and measure the wall space and rough-in distances at each position.
3. Clearances
Check there's enough clear floor space in front of and beside each fixture to use it comfortably, not just enough to fit it in.
Related Guides
Go deeper on each fixture.
See our sink dimensions guide and commode dimensions guide for the specific measurements each fixture needs.
Before You Start
What you need and how to prepare.
You need a tape measure, a notepad or your phone, a pencil, and ideally a second person to hold the end of the tape. Draw a rough sketch of the room first and write each measurement on it as you take it. Use one unit throughout, either millimetres or centimetres, so nothing gets mixed up. Take photographs as you go, with the tape visible, so you can check things later.
Step by Step
The measurements to take.
The room. Measure the length and width, and note the ceiling height if you are considering wall-hung pieces. Mark the door, the way it swings, and any window.
The commode position. Note whether the waste goes into the floor or the wall, and measure from the wall to the centre of the waste outlet. Measure the clear width beside and the clearance in front. See P-trap vs S-trap and the commode measuring guide.
The basin position. Measure the wall width and depth available, the position of the waste and the water supply, and the clearance beside and in front. See basin sizing.
Water and drainage. Note where the water supply comes out and where the waste leaves the room. If you are considering a standing bidet, note whether a supply and a drain can reach the spot.
The walls. If you are thinking of wall-hung pieces, find out whether the wall is solid or hollow and whether it can take a frame or fixings.
Double-Check
Check twice, then check against the product.
Measure each dimension twice. Measure to the finished wall surface where you can, especially if you are about to tile, because tiles change the available space. Then compare your measurements with the exact dimensions of the pieces you are considering, and leave a little tolerance rather than planning to the last millimetre. Confirm the plumbing positions with your plumber before you order.
Send Us Your Measurements
What to send us.
If you would like help checking a piece against your space, Message us on WhatsApp with your sketch, the measurements, a few photographs with the tape in view, and a note of whether the waste goes into the floor or the wall. We will help you check the fit. See also planning a sink and commode together and new build vs renovation.
Questions
Common questions.
What should I measure first?
Start with the overall room dimensions and door position, then measure the specific wall space at each fixture location.
Do I need a plumber to measure?
Basic room measurements can be done yourself, but confirming rough-in distances and plumbing positions is best done with a plumber before ordering.
Which measurement matters most for a commode?
Whether the waste goes into the floor or the wall, and the distance from the wall to the centre of the waste outlet. Together they decide which commodes will fit without moving the plumbing.
Should I measure to the finished wall or the bare wall?
To the finished wall surface where possible, especially if you are about to tile, because tiles reduce the space.
What do I need to measure for a basin?
The wall width and depth available, the positions of the waste and water supply, and the clearance beside and in front of the basin.
Can I send you photos instead of measurements?
Photographs with a tape measure in view help a great deal, together with your measurements. Message us on WhatsApp and we will talk it through.